Hooking Up Hydraulic Spinner To Tractor Remotes - Handler PT-6 FSS Manual

Hooking up Hydraulic Spinner Option to Tractor Remotes
When hooking up Hydraulic Spinner Option use the following procedure.
Connect Pressure Hose to tractor remote using coupler marked for the Lower Position.
(Symbol indicates Lower Position)
This will turn the spinners in proper direction when lever is in the Lower position.
If tractor is equipped with hydraulic motor return option (low pressure return circuit) Connect
Return Line here
Or
Connect Return Hose to tractor remote using coupler marked for the Raise Position.
(Symbol indicates Raise Position)
Many of today's tractors you can select for a motor or cylinder. Be sure that you have selected
Motor not Cylinder. (This will also allow oil to flow similar to a low-pressure circuit)
(John Deere Tractor shown symbols may very on different manufactures)
When hooking up any hydraulic lines to tractor turn engine "OFF" and
Caution:
make sure all Remote Levers are in the neutral position.
Hydraulic hoses can fail due to physical damage, kinks, age and
Important:
exposure.
Check hoses daily and replace faulty hoses immediately to avoid possible
personal injury or damage to equipment.
5 - 8