Related Manuals for ICI APEX 200
Summary of Contents for ICI APEX 200
- Page 1 Edit Text Industry APEX 200 QUICK START GUIDE ICI cameras fall under US Federal Law and Export Control. 2105 W. Cardinal Dr. Beaumont, TX 77705 Phone: (409) 861-0788 Toll Free: (866) 861-0788 infraredcameras.com support@infraredcameras.com We Are IR ™...
- Page 2 IN NO EVENT SHALL ICI BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF ICI HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
-
Page 3: Package Includes
Package Includes APEX 200 Ethernet Cable POE Ethernet Cable Power Adapter PoE Injector M2 Screws x8 Alignment Guides ST2.2 Screws x8 ENSURE ALL SYSTEM EQUIPMENT AND COMPONENT ITEMS ARE PRESENT BEFORE BEGINNING INSTALLATION... - Page 4 THE THERMAL DEVICE WILL ACCUMULATE HEAT DURING OPERATION. ICI RECOMMENDS MOUNTING THE THERMAL DEVICE TO METALLIC OBJECTS AT ITS REAR HOUSING WHICH CAN REDUCE DEVICE HEATING AS WELL AS DECREASE THE TEMPERATURE DRIFT OF THE DETECTOR.
- Page 5 Align the 8-pin connector of Rotate the securing nut to the the POE Ethernet cable to the right to lock cable in place. 8-pin receptor on the device; Rotate the securing nut to the then, plug in the cable. left to unlock the cable. ALIGN THE PINS BEFORE TRYING TO CONNECT THE POE ETHERNET CABLE.
- Page 6 Plug the power adapter into a Plug one end of the Ethernet 110/120V electrical outlet. cable into the front of the PoE injector. Power on device. Plug the other end of the Ethernet cable into the back of the network router. THE THERMAL IMAGER NEEDS SUFFICIENT WARM-UP TIME FOR THE MOST ACCURATE TEMPERATURE MEASUREMENTS AND BEST IMAGE QUALITY.
- Page 7 THE THERMAL DEVICE WILL ACCUMULATE HEAT DURING OPERATION. ICI RECOMMENDS MOUNTING THE THERMAL DEVICE TO METALLIC OBJECTS AT ITS REAR HOUSING WHICH CAN REDUCE DEVICE HEATING AS WELL AS DECREASE THE TEMPERATURE DRIFT OF THE DETECTOR.
- Page 8 Align the 8-pin connector of Rotate the securing nut to the the POE Ethernet cable to the right to lock cable in place. 8-pin receptor on the device; Rotate the securing nut to the then, plug in the cable. left to unlock the cable. ALIGN THE PINS BEFORE TRYING TO CONNECT THE POE ETHERNET CABLE.
- Page 9 Plug the power adapter into a Plug one end of the Ethernet 110/120V electrical outlet. cable into the front of the PoE injector. Power on device. Plug the other end of the Ethernet cable into the back of the network router. THE THERMAL IMAGER NEEDS SUFFICIENT WARM-UP TIME FOR THE MOST ACCURATE TEMPERATURE MEASUREMENTS AND BEST IMAGE QUALITY.
- Page 10 Website: www.infraredcameras.com You may reach a representative by phone or email Mon – Fri 8:00AM - 5:00PM CST. ICI manufactures complete systems and software. We can provide complete engineering, software, and OEM solutions. Our Fortune 500 clients rely on us for infrared equipment and thermography training (which we offer through the Infrared Training Institute).