Volvo Penta TAMD71B Instruction Manual page 7

Marine genset engine
Hide thumbs Also See for TAMD71B:
Table of Contents

Advertisement

Clutch adjustments, where a clutch is fitted, must be carried out with the engine turned off.
Use the lifting eyes fitted on the engine when lifting the drive unit. Always check that the lifting
equipment used is in good condition and has the load capacity to lift the engine (engine weight
including any extra equipment installed).
Use a lifting beam to raise the engine to ensure safe handling and to avoid damaging engine
parts installed on the top of the engine.
All chains and cables should run parallel to each other and as perpendicular as possible against
the side of the engine.
If extra equipment is installed on the engine which alters its center of gravity a special lifting de-
vice is required to obtain the correct balance for safe handling.
Never carry out work on an engine suspended on a hoist.
WARNING! The components in the electrical system and in the fuel system on Volvo Penta
products are designed and manufactured to minimize risks of fire and explosion.
The engine must not be run in areas where there are explosive materials.
Fuel filter replacement should be carried out on a cold engine in order to avoid the risk of fire
caused by fuel spillage on the exhaust manifold. Always cover the generator (alternator), if it is
located under the fuel filter. The generator (alternator) can be damaged by spilled fuel.
Always use protective gloves when detecting leaks. Liquids ejected under pressure can pene-
trate the body tissues and cause serious injury. Danger of blood poisoning.
Always use fuels recommended by Volvo Penta. Refer to the Instruction Book. Use of fuels that
are of a lower quality can damage the engine. On a diesel engine poor quality fuel can cause
the actuating rod to seize and the engine to overrev with resulting risk of damage to the engine
and personal injury. Poor fuel quality can also lead to higher maintenance costs.
Observe the following when cleaning with high-pressure water jets. Never point the water jet at
seals, rubber hoses or electrical components. Never use high pressure jets when washing the
engine.
5
AB Volvo Penta / Diesel Engine TAMD71B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents