Product Assembly; Preparing The Food Chopper For Use; Product Usage - KitchenAid 5KFC0516 Owner's Manual

PRODUCT ASSEMBLY

PREPARING THE FOOD CHOPPER FOR USE

Before first use
Before using the Food Chopper for the first time, wash the Work Bowl, Lid, Whisk, and Blade in
hot, soapy water. Work Bowl, Lid, and blade may also be washed in the top rack of a
dishwasher.
For convenient storage, always reassemble the Food Chopper after cleaning.
ASSEMBLING AND RUNNING THE FOOD CHOPPER
IMPORTANT: Be sure the Food Chopper is unplugged before assembling.
1.
Start with the Work Bowl Handle facing front on the base. Rotate the handle
90° counterclockwise to lock into place. When assembled properly, the handle will face the
right side.
2.
Fit Drive Adapter over the shaft in the centre of the Work Bowl, then rotate and lower the
Drive Adapter until it rests at the bottom of the Work Bowl.
3. If using the blade, fit the blade over the Drive Adapter, then rotate and lower the blade until
it rests at the bottom of the Work Bowl. If using the whisk, see "Whisking Accessory
Usage" section.
NOTE: Do not try to install more than one accessory at a time. The Food Chopper will
operate with either the blade or the Whisking Accessory in place, not both.
4.
Place ingredients to be processed inside the Work Bowl. For uniform consistency of
processed foods, cut fruits, vegetables, and meats into 2.5 cm pieces.
IMPORTANT: Do not process coffee beans or hard spices such as nutmeg as they may
damage the Food Chopper.
5.
Place the Lid on the Work Bowl with the Lid handle facing front. Rotate the Lid handle
counterclockwise until it locks into place. The Lid will click when properly locked into place.
NOTE: The Work Bowl and Lid must be locked into place for the Food Chopper to operate.
6.
Slide the Speed Selection Lever to your desired setting. Press down on the PULSE/ON
Button to start the Food Chopper.
7.
For a coarse chop, use a pulsing motion to rapidly press and release the PULSE/ON
Button until your desired results are achieved.

PRODUCT USAGE

WHISKING ACCESSORY USAGE
1.
Fit the Whisking Accessory over the Drive Adapter, then rotate and press down until it
rests at the bottom of the Work Bowl.
2.
Place ingredients to be processed inside the Work Bowl.
3.
Place the Lid on the Work Bowl with the Lid handle facing front. Rotate the Lid handle
counterclockwise until it locks into place. The Lid will click when properly locked into place.
4.
Slide the Speed Selection Lever to your desired setting. Press and hold the PULSE/ON
Button to start the Food Chopper.
6