Electrical Diagram (110 - 240Vac) - QUBINO ZMNHCD6 User Manual

9. Electrical Diagram (110 - 240VAC)

N Neutral wire
L Live (line) wire
Q1 Output for motor UP (open)
⬆
Q2 Output for motor DOWN (close)
⬆
I2 Input for switch/push button DOWN (close)
I1 Input for switch/push button UP (open)
TS Temperature sensor terminal
S Service button
WARNING
The S (Service) button must NOT be used when the device is connected to a 110-240V power
supply. The durability of the device depends on the load connected. Resistive loads (light bulbs,
etc.) and loads that consume up to 4A, the product's lifespan exceeds 70,000 toggles.
OVERLOAD PROTECTION
Max Power Limit is automatically set by software. When the current exceeds 4A for more than 5
seconds, the load is automatically turned off. An "overload detected" notification is sent to your
gateway/hub. To reactivate the device, power supply must be turned OFF and ON again.
Notes for diagram:
34
EN.