Monster iCruze MPC FX IC-FD3 Installation & User Manual page 6

Step 3
The blue with white stripe wire goes
between both ends of the cable. In the
middle is a connector that comes apart.
Pull the ends to disconnect them. The
female end is not used and can be left alone.
Step 4
Cut off the male 'bullet' end and connect
this to 12 volt accessory power.
Step 5
The Interface Cable from the iCruze box
(steps 1-3) plugs into the "OEM Interface"
port on iCruze with the rectangular
or Molex ® end.
Step 6
Consult the chart on the next page
and find your specific vehicle. This
will help you locate where the factory
tuner/amplifier box you need to plug
the FD3 Interface Cable into resides.
If you are uncomfortable removing factory panels,
professional installation is highly recommended.
Step 3
Step 5
Yellow wire
connected to 12v
constant power
(step 2)
Model Year
Ford
Explorer 95-97
Crown Victoria 95-97
Taurus 96-04
Lincoln
Continental 95-97
Town Car 95-97
Mercury
Grand Marquis 95-97
Mountaineer 97
Sable 96-04
The FD3 Cable Plugs into the Factory Tuner/Amplifier
*
at this Location
Qualifier Cable Plug-In
Location
With JBL RR Quarter
*
System
With JBL or Trunk
*
LUX System
With CD Trunk
*
Capable Radio
With JBL or Trunk
*
LUX System
With JBL or Trunk
*
LUX System
With JBL or Trunk
*
LUX System
With JBL or RR Quarter
*
LUX System
With CD Trunk
*
Capable Radio