GE DPS 5000 Series User Manual page 3

Safety
The manufacturer has designed this sensor to be safe when operated using the procedures
detailed in this manual. Do not use this sensor for any other purpose than that stated.
This manual contains operating and safety instructions that must be followed for safe
operation and to maintain the sensor in a safe condition. The safety instructions are either
warnings or cautions issued to protect the user and the equipment from injury or damage.
Use qualified personnel and good engineering practice for all procedures in this manual.
Qualified personnel must have the necessary technical knowledge, documentation, special
test equipment and tools to carry out required work on this sensor.
Pressure Do not apply pressure greater than the maximum safe working pressure
to the sensor.
Toxic materials There are no known toxic materials used in the sensor.
Maintenance The sensor must be maintained using the manufacturer's procedures
and these should be carried out by authorised service agents or the
manufacturer's service departments.
Technical advice For technical advice contact the manufacturer.
EC Directives This sensor complies with the requirements of the Pressure Equipment
Directive 97/23/EEC and the EMC directive 2004/108/EC
For further details refer to the Sales Data Sheet or the customer
specification drawing.
A full conformity certificate is available from the manufacturer.
Contact GE Measurement & Control
1
The EMC directive is only applicable to the external variant (model E503D)
K0582 Revision B
www.gemeasurement.com
May 2015
.
1
i