nystrom EJ-EWN-200MB Quick Start Manual

Elastomeric exterior wall system expansion joint

Advertisement

Elastomeric Exterior Wall System Expansion Joint
Model(s): EW/200MB/300MB/400MB/500MB/600MB

GENERAL DESCRIPTION

Introduction + Safety

Please read the complete instructions carefully before beginning any work. To ensure proper
Installation and performance of the Roof Hatch, the following actions must be completed by
the installing contractor. Failure to do so will affect product warranty.

Transportation + Storage

GENERAL SAFETY PRECAUTIONS
is solely the responsibility of the user, through its own analysis to select products suitable for their specific application
requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow proper local,
state and federal regulations for proper installation and operation requirements.
o Inspect all shipments and materials for missing or damaged components and hardware.
o Material must be stored in a clean, dry location.
This Elastomeric Exterior Wall System is a weather tight system that
accommodates thermal and seismic movement. The visual seal
matches many exterior building colors and the rear moisture
barrier prevents and exterior moisture or condensation from
entering the wall cavity.
Improper selection, installation, or use can cause personal injury or property damage. It
Installation, Operation
©2020 Nystrom, Inc.
1
Rev/2020

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EJ-EWN-200MB and is the answer not in the manual?

Questions and answers

Summary of Contents for nystrom EJ-EWN-200MB

  • Page 1 Follow proper local, state and federal regulations for proper installation and operation requirements. o Inspect all shipments and materials for missing or damaged components and hardware. o Material must be stored in a clean, dry location. ©2020 Nystrom, Inc. Rev/2020...
  • Page 2 * Additional components needed for adhesive installation. Place order for required quantities. ** Optional components for splice procedures. Place order for required quantities Components Visual Seal Color Part Number Model Black White Seal Gray Seal Beige Seal Seal EJ-EWN-200MB EJ-EWN-300MB EJ-EWN-300MB EJ-EWN-400MB ©2020 Nystrom, Inc. REV JUL/2020...
  • Page 3 Fig. 1 proceeding to next step. o Always review architectural plans for specific project requirements Note o For Standard Installation, continue to step 4 o For adhesive installation, continue to step 6 ©2020 Nystrom, Inc. REV JUL/2020...
  • Page 4 It is usually recommended to allow 15 minutes time before installing spliced seal. Care shall be exercised as a result that it takes 24 hours for adhesive to fully cure. Fig. 5 ©2020 Nystrom, Inc. REV JUL/2020...
  • Page 5 Expansion Joints are designed and built for years of dependable service. MAINTENANCE o Annual inspections should be performed to make sure the system is still in position. Repair and/or replace as needed. QUESTIONS? For more information on installation, repair or replacement, please visit www.Nystrom.com ©2020 Nystrom, Inc. REV JUL/2020...

This manual is also suitable for:

Ej-ewn-300mbEj-ewn-400mb

Table of Contents