nystrom EJ-FLF140 Installation, Operation And Maintenance Manual

Seismic Fire Barrier Expansion Joint System
Model(s): EJ-FLF140/EJ-FLW140

GENERAL DESCRIPTION

GENERAL SAFETY PRECAUTIONS Improper selection, installation, or use can cause personal injury or property damage.
It is solely the responsibility of the user, through its own analysis to select products suitable for their specific
application requirements, ensure they are properly maintained, and limit their use to its intended purpose. Follow
proper local, state and federal regulations for proper installation and operation requirements.
Installation

Preparation

Please read the complete instructions carefully before beginning any work. To ensure proper
installation and performance of the expansion joint system the following actions must be
completed by the installing contractor. Failure to do so will affect product warranty.
o Inspect all shipments and materials for missing or damaged components and hardware.
o Verify joint width in field prior to ordering system. Minimum joint width of 2 inches
(51mm).
o Verify the structural gap and blockout dimensions are in conformance with submittal data
before beginning installation. Certification of this product was completed by Intertek
Testing laboratories. Product must be installed in accordance with these Installation
Instructions.
o Ensure joint is plumb and square, also verify soundness of substrate. Repair any spalls or
cracks prior to proceeding.
o For vertical (wall) conditions, single-sided and double-sided blankets are available. For
single-sided product, ensure drape of blanket faces "potential" threat" side of wall.
Expansion Joint Systems are an important life safety requirement
in current building codes. These systems allow safe movement
when buildings shift due to expansion and contraction.
The following are general instructions for installing, operating and
maintaining Expansion Joint Systems.
Installation, Operation
+ Maintenance Manual
©2020 Nystrom, Inc.
1