Panasonic WV-Q169 Instructions Manual page 3

Avoid installing in the following locations.
• Locations where it may get wet from rain or water splash
• Locations where a chemical agent is used such as a swimming pool (not only outdoor)
• Locations subject to steam and oil smoke such as a kitchen
• Locations where radiation or x-ray emissions are produced
• Locations where it may be damaged by briny air such as seashores
• Locations where the temperature is not within –10 °C to +50 °C {14 °F to 122 °F}.
• Locations subject to vibrations (This product is not designed for on-vehicle use.)
• Locations where the temperature may rapidly change such as the peripheral areas of the
air outlets of air conditioners or doors facing outside. (In case of installing the camera in
such locations, the dome cover may become foggy or condensation may be caused on the
cover.)
Tightening the screws and bolts
• The screws and bolts must be tightened with an appropriate tightening torque according to
the material and strength of the installation area. After tightening the screws or bolts, per-
form visual check to ensure tightening is enough and there is no backlash.
• Required pull-out capacity of a single screw/bolt is 196 N {44.1 lbf} or more.
Do not rub the edges of metal parts with your hand.
Failure to obsere this may cause injury.
Be sure to remove this apparatus if it is not in use.
Be sure to install the safety wire.
Use the specified camera only.
Failure to observe this may cause a fall of an inappropriate camera resulting in injury or acci-
dents. Mount WV-NW484S on this bracket exclusively.
Periodic inspections shall be conducted.
Rust on the metal parts or screws may cause a fall of the product resulting in injury.
Consult the dealer for the inspections.
3