Camera Preset Position - Panasonic WV-CU360C Operating Instructions Manual

Camera Preset Position

There are two ways of presetting camera positions.
One is to use the camera setup menu of the combination
camera and the other is to operate the System Controller as
follows.
1. Select the desired system unit, monitor and camera.
2. Move the camera to a position you wish to preset, using
the joystick.
L
Adjust the picture using the following buttons.
• Iris (Open/Close)
• Focus (Far/Near)
• Zoom (Tele/Wide)
Note: The memorized parameters may differ somewhat
depending on the camera type. Refer to the manual
included with the camera.
3. Type a number with the numeric buttons for the pre-
set position. The typed number appears in the
CAMERA section of the LED display.
37
UP
R
DOWN
MON CAM
LOGOUT
ESC SET
4. Press the HOME/PRESET/PROGRAM PRESET button
while holding down the PROGRAM/CAM SETUP/CAM
FUNCTION button.
The position and its number are memorized for later
recall.
PROGRAM
CAM SETUP
CAM FUNCTION
HOME/PRESET
PROGRAM
PRESET