Operation - Westfalia 91 94 13 Original Instructions Manual

Mounting and Connection
Attention: Only qualified personnel are allowed to work on electrical systems
in vehicles. For installing the LED work light observe the regulations and safety
instructions.
For mounting the LED work light on the vehicle, use the included mounting
material (3) and the bracket (2) or other bolts or screws that are suitable for
the ground.
In road transport always switch off the LED work light!
1. Connect the black cable with the minus pole of the battery or with a non-
painted surface of the chassis.
2. Finally connect the
Hints:
 Operate the LED work light with an ON/OFF switch (e. g. a toggle switch) in
order to switch on the light only when it is needed. When using a switch,
make sure the switch is equipped with a current load rating of at least 12 A.
 Do not operate the work light unnecessarily as this will shorten the life span
of the LED.
Maintenance and Cleaning
 Clean the LED work light frequently to maintain full brightness.
 Do not clean the unit with aggressive detergents but rather use a dry or
lightly moistened cloth to clean the unit.
Technical Data
Type:
Nominal Power:
Output:
Degree of Protection:
Power Cable Length:
Dimensions:
Weight approx.:
LED (Pieces):
LED Colour:
Light Intensity:
Radiation Angle:
Operating Temp.:

OPERATION

red cable to the plus
5JG-W161-F
9 – 32 V
48 W
IP 67
26 cm
110 x 72 x 110 mm
0.7 kg
16
White
3071 Lumen
60°
-40° C – +50° C
10
pole of the battery.