Intended Use
This article is for decoration only. The article is not for household lighting. It is
only for indoor use!
Inserting the Batteries
1. Unscrew the small screw with a screwdriver and open the battery
compartment opening the latch and removing the cover. Insert three bat-
teries of the type LR6 (AA) into the battery compartment.
2. Close the battery compartment. Observe the polarity symbols in the
battery compartment. Re-tighten the small screw.
Operation
1. Put the stand of the Magic Village on a level
and solid surface.
2. Set the ON/OFF switch to the "ON1" position
to start-up the Magic Village with light and
music. All available music titles will be played
in a sequence.
3. Set the ON/OFF switch to the "ON2" position to operate the Magic Village
with light only. Set the ON/OFF switch to the
"OFF" position to switch off the device.
Stopper
To prevent the Magic Village ball from accidental-
ly slipping off the stand, slide the stopper over the
end of the stand, as shown in the picture (similar
illustration).
Cleaning and Storing
Clean the Magic Village only with a soft dry cloth or with a suitable soft
brush. Do not use detergents or chemicals as this may damage the sur-
faces.
Store the Magic Village indoors in a dry place that is protected from dust,
dirt and extreme temperatures. Store the Magic Village out of reach of
children.
Technical Data
Dimensions:
Weight:
Ø 20 x H 25 cm
1911 g with Stand (w/o Batt.)
Operation
6
OFF
ON1
Battery: 3x LR6 (AA)
ON2