Electronic Board Operations Check - Panasonic UB-2315C Operating Instructions Manual

Electronic Board Operations Check

After assembling the unit, perform the procedures presented in the following table to make sure it functions properly.
Step
1
Turn the power switch on.
2
Set the time.
(Refer to "Setting the current
time" on page 20.)
3
Connect a USB flash memory
device or SD memory card.
(Refer to "Scanning" on page
14.)
4
Use the accessory marker to
draw a large
the entire scannable area of
the whiteboard surface.
• For information on the
scannable area, refer to
"Whiteboard" on page 10.
Press the Start/Stop key.
5
Zoom in on several areas of the
scanned image.
(See page 15 or 16.)
6
Rotate the whiteboard.
(Refer to "Rotating the
Whiteboard" on page 18.)
7
Turn off the power switch, then
turn back on after 3 minutes.
46
Condition
Time set-up message is displayed
after initial message is displayed.
(If not)
The time can be set.
The time cannot be set.
The USB flash memory device or
SD memory card installed is
recognized and is shown on the
display.
(If not)
The scanner moves smoothly and
the scanned image appears on the
across
display.
The scanner does not move
smoothly.
A strange noise is made.
The scanned image is not
displayed.
The entire scannable area is not
scanned.
The image on the display matches
the image on the whiteboard.
A black or white horizontal line
appears on the scanned image, or
the image scanned is dark or
blank.
The whiteboard can be rotated
normally.
The whiteboard cannot be rotated.
The standby message is displayed
after the initial message is
displayed.
The time is not correct.
Points to Check
Solutions
(Normal operation)
Check the power cord. (See
step 8 on page 45.)
(Normal operation)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Check the connector.
(See step 7 on page 45.)
Check the scanner attachment.
(See step 7 on page 45.)
Contact the store or dealer from
which the unit was purchased.
(Normal operation)
Check the white balance area,
scanner lens and strong lighting.
(Refer to "Troubleshooting" on
page 32.)
(Normal operation)
Check the whiteboard
attachment.
(See step 6 on page 44.)
(Normal operation)
Check the battery.
(See page 31.)