Advertisement
2 Install LMU Controller
With the supplied alcohol wipe pad, clean the vehicle surface where the LMU Controller will be installed.
Choose a dry location with easy access to the electrical panel and cable connections, including the antenna's.
Using the provided Velcro, attach the LMU Controller to a secure location. Install in the front of the vehicle
where the LEDs can be seen.
The unit can be mounted in any direction.
3 Connect LMU Controller
Use the following diagram to connect the LMU Controller with the other system components.
IMPORTANT
If the LMU is being connected to a DVR and the DVR has a GPS4 unit installed, the GPS4 unit can be
removed. The LMU Controller replaces GPS4 functionality on the DVR.
4 Install the Antenna
Find an appropriate spot on the inside of the front
windshield out of the way of the driver's view to Install the
GPS/Cellular Antenna on a glass surface, not metal.
Use the provided isopropyl alcohol wipe pad to clean the
vehicle surface before installation.
5 Install Signal Connections
Install signal connections as required.
6 Hardware Checklist
Confirm the following are all complete for the LMU Controller installation.
Harnesses
The voltage at the power supply cable is at least
11 VDC
Cables and the harnesses are properly secured
No sharp metal edges are touching the cables
or harnesses
Connections are solid (no shorts).
LMU Controller
Check for tight mounting of hardware and
connections
System
Switch the vehicle ignition ON
Confirm DVR firmware is up to date
LMU Controller LED indicators work properly
GPS sensor and cable connections to DVRs are working
Installation Record Details
165mm (6.5")
Advertisement
