OPERATION
2. Operate accessory tool as normal (Figure 7).
NOTE: Before cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
FIG. 7
3. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning switches off.
DRAINING TANKS
DRAINING RECOVERY TANK
1. Turn machine off and unplug power cord.
2. Insert supplied 45° elbow in drain valve. Place a
bucket below it and slowly pull up on the handle
(Figure 8).
FIG. 8
3. Rinse tank with clean water at the end of the day.
PX-1100LP (07-00)
Home
DRAINING SOLUTION TANK
1. Remove empty-out nozzle from its storage
2. Place empty-out nozzle over a bucket and turn on
3. Replace empty-out nozzle to its storage location.
FREEZE PROTECTION
1. After draining solution tank as described in steps
2. Turn on vacuum and pump for 15 seconds. This
3. Replace empty-out nozzle to its storage place.
Find... Go To..
bracket (Figure 9) and attach to end of solution
hose.
FIG 9
pump until all the solution has been pumped from
solution tank.
one and two in the previous section (DRAINING
SOLUTION TANK), place empty-out nozzle in
end of vacuum hose and seal with hand
(Figure 10).
FIG. 10
will fill the pump and hoses with air and prevent
freezing.
7