Table of Contents
Advertisement
OPERATION
ATTENTION: If using powdered cleaning
chemicals, mix prior to adding.
NOTE: If desired, water alone achieves excellent
cleaning results.
5. Plug machine's power cord into a grounded wall
outlet (Figure 3).
GROUNDED OUTLET
(3 hole)
GROUNDING
PIN
Fig. 3
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
6. Secure recovery tank lid in place.
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE-OPERATION
1. Vacuum carpet and remove other debris.
2. Inspect power cord for damage.
CLEANING CARPETS
1. Activate vacuum and pump switches (Figure 4).
Fig. 4
6
Home
2. Take carpet cleaning wand in hand and squeeze
WHILE OPERATING
1. Overlap each path by 50 mm (2 in).
2. Periodically check for excessive foam buildup in
ATTENTION: Excessive foam buildup will not
activate the float shut-off screen.
3. To clean heavily soiled areas, repeat cleaning
4. Empty recovery tank every time water is added to
CLEANING WITH ACCESSORY TOOLS
1. Connect accessory tool hoses to the couplers at
Find... Go To..
valve trigger while moving the tool in short
forward and backward strokes over the carpet
(Figure 5).
Fig. 5
Warning: Flammable materials or reactive
metals can cause an explosion or fire. Do not
pick up.
recovery tank. Use a recommended foam control
solution to prevent vacuum motor damage.
path from a different direction.
solution tank.
the end of the hoses already attached to the
machine (Figure 6).
Fig. 6
PX-1100LP (07-00)
Advertisement
Table of Contents
