Table of Contents
Advertisement
5 – Installation
continued
WARNING!
Before wiring make sure that all breakers (including the Distribution Center's Main Breaker) are in the OFF position and
that the 3-phase power source is de-energized!
5.2 Installing Breakers
1
Open the Distribution Center's front door to access the breaker box.
2
Remove 6 screws
A
from the breaker box front panel, then remove
the panel and set it aside.
3
Decide which pole position to use for each of your required breakers
and snap each breaker into place.
4
Remove the corresponding panel knockouts from the breaker box
front panel.
Note: Properly label your breakers in the spaces provided to
better manage your electrical system (labels not included). You
may also want to differentiate labeling between different racks
and cord sets.
5.3 Installing Cord Sets
1
Pass the cord set through one of the cable access channels in the
roof of the Distribution Center, ROJ section first. The channel you
choose depends on your cord set configuration.
2
Select a knockout in the breaker box and remove the insert for
that knockout. The knockout you choose depends on your cord
set configuration. Note: There are (24) ¾-inch knockouts and (29)
½-inch knockouts distributed throughout the breaker box.
3
Remove the coupling nut of the strain relief connector from the cord
set.
4
Insert the ROJ section of the cord set through the knockout and into
the breaker box. (Pull the ROJ section through the knockout until
the threaded end of the strain relief connector is inside the breaker
box.)
5
Insert the ROJ section of the cord set through the coupling nut of the
strain relief connector.
6
Attach the coupling nut to the strain relief connector and tighten,
securing the cord set to the breaker box.
Output
Breaker
Breaker Box Interior
AC Connector
Cord
9
A
Breaker Box Front Panel
Coupling Nut
Cord Set
Coupling Nut
Strain Relief
ROJ Section
Connector
Advertisement
Table of Contents
