Advertisement
Available languages
Available languages
CONNECTIONS _______________________________
Use the HDMI cable to connect the
HDMI-ARC input port of this sound bar
to the ARC output port of the liquid-
crystal display television. Press " „
button repeatedly on the remote con-
trol to select ARC mode.
Your TV digital sound out-
C
put S/PDIF mode setting
must be PCM or Dolby
Digital.
Bluetooth
Press "STANDBY„ button on the remote
control to power on the sound bar, then
press " „ button on the remote control
to switch the bluetooth mode, the word
"no bt" will be shown on the display
screen, the sound bar is in searching
bluetooth signal status, use your smart
phone to search the bluetooth signal of
the sound bar, select Grundig DSB 995
on your list, input the password 0000 if
need the password prompt, the sound
bar will synchronize to play songs on
your mobile phone while the word "bt"
is shown on the display screen and a
beep will be heard means to be connec-
ted successfully.
Disconnected the bluetooth on the
smart phone to switched off the blue-
tooth connection.
• Bluetooth
range in 10 meters.
• The model Grundig DSB
C
995 in your device was not
deleted.
• In bluetooth mode, [PLAY/
PAUSE], [NEXT], [PREVI-
OUS], [VOLUME+/-] etc.
are also active.
16 ENGLISH
Subwoofer connection
Make sure the AC power cord for the
subwoofer is connected to a power
supply securely. Power on the sound
bar, press and hold " „ button for 5 se-
conds, the subwoofer can receive the
wireless audio signal from the sound
bar. when the red indicator flashing on
the subwoofer, the subwoofer is in se-
arching wireless signal status, the blue
indicator keeps lighting on the subwoo-
fer means the sound bar and subwoo-
fer was connected. Press and hold
"PAIR„ button on the Subwoofer or
press and hold " „ button for 5 se-
conds to disconnect with the sound bar
and the red indicator on the subwoofer
flashing when the subwoofer and
sound bar was connected, press "PAIR„
button on the Subwoofer or press and
hold " „ button on the sound bar for 5
seconds again, the subwoofer will be
reconnected with the sound bar.
connection
USB
1. Insert USB storage drive into the USB
2. Press " „ button repeatedly on the
slot on the rear panel.
remote control to select USB mode.
Advertisement
