Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
1
Unpack the high bay fixture and put upright. Check that the lamp body isn't damaged.
Suspension ring
2
Install the suspension ring properly and fix it with the safety bolt. Hang the fixture with a snap hook.
3
Adjusting light output.
ON
18,000Lm
100W
1
2
3
ON
21,000Lm
120W
1
2
3
ON
25,500Lm
150W
1
2
3
ON
32,000Lm
200W
1
2
3
4
Make connection with mains supply as per following instruction and turn on the fixture.
Brown: L
Blue: N
Yellow and green:
0-10V dimming
Purple: DIM+
Gray: DIM-
www.prolumia.com
a. Make sure the power supply is
switched off
b. Open the rubber plug on the side
of the power supply
c. Set the DIP switches to the required
power setting
d. Use a tool, such as a small screwdriver,
to adjust the dip switches accordingly
e. Put the rubber plug back again and
ensure it is fixed well
7
Advertisement
Table of Contents
