Technical Data; Technical Information - PROLUMIA PRO-BAY III Operating Instruction

ATTENTION
Please read the following instructions carefully to ensure that installation operation will be carried out correctly. These instructions
should be properly preserved for future reference.
CAUTION
1. Before opening the packaging, please check whether any damage or defects have occurred during transport. If damage occured, please don't use
the product, keep it in the packaging and inform your supplier immediately.
2. To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected, and maintained by a qualified electrician only.
Supplier is not responsible for any problems or damage that may occur due to misuse, such as an operation not permitted according to this manual.
3. Choose an installation surface that can withstand 10 times the weight of the product to ensure a solid installation.
4. Wipe the cover and lens with a soft cloth and a little neutral detergent. Be sure not to use any sandpaper, polishing powder, alcohol, gasoline, liquor,
and so on.
5. A high pressure air blower is recommended to clean the heat sink of this LED high bay fixture.
6. Make sure electrical power is off before and during installation and maintenance.
7. The external flexible cable or cord of this fixture cannot be replaced.
8. A terminal block is not included. Installation may require advice from a qualified person.
9. This IP65 fixture can be used indoors only.
10. The fixture should be installed out of arms reach.
11. Caution, risk of electric shock.
12. This product contains a light source of energy efficiency class C.

TECHNICAL DATA

Light source: LED SMD2835
Beam angle: 55°/85°/110°
Power consumption: 100W – 200W
Light output (switchable):
18,000Lm / 21,000Lm / 25,500Lm / 32,000Lm
Max. efficiency: 180 Lm/W
Color temperature: 4000K
Color rendering index: Ra >80
Supply voltage: 220-240V AC 50/60Hz
Power factor: >0.95
Operating temperature: -30°C~+50°C
Electrical safety class: Class I
Net. weight: 2.9 kg

TECHNICAL INFORMATION

Art.no. Beam angle
40643403 110°
40643404 85°
40643405 55°
STANDARD CABLE CONFIGURATION
• 0.3m VDE/UL certified rubber cable
• Diameter of 3x 1.0mm2
• With cold-pressed terminal
6
ø 331 mm
www.prolumia.com
ø 217 mm
ø 331 mm