Table of Contents
Advertisement
confirm with ENTER button to start auto searching of channels. Just wait until all channels are found. Now you can enjoy digital
Tv. If no channels are found, check antenna connection, or check if correct values of network are entered. Start from beginning
the installation trough menu/ option/ Installation Guide.
4.0 ELECTRONIC PROGRAMME GUIDE (EPG)
EPG stands for Digital Electronic Programme Guide. It is supplied by the programme providers and offers information on
broadcasted programmes. You can access it in digital mode by pressing EPG on the remote control. Press EPG to bring up the EPG
interface. Use
to select a channel.
pq
Press INDEX
to switch to overview from one channel EPG. Use
u
EXIT to stop and return to viewing modes.
Then press the COLOUR BUTTONS for entering the required settings.
GREEN
Information
YELLOW
Schedule List
BLUE
Set a reminded to event or set even Timer function.
5.0 MENU SETTINGS
Below items depend if they are available of select input source. Use SOURCE to select other source. Selections are DTV, ATV,
HDMI, AV, and USB Media.
5.1 MENU CONTROL (DTV MODE)
Press MENU to enter the main menu. Press
item.
5.2 CHANNEL
Press MENU to display the main menu. Press ENTER to select Channel in the main menu. Press
to adjust in the Channel menu.
Press ENTER to enter sub menu. After finish your adjustment, press MENU to save and return to the previous menu. Below items
depend if they are available of select input source. Use SOURCE to select other source.
5.2.1 ANTENNA TYPE
Press ENTER to select which antenna type you want to use. Select between, Air, Cable or Satellite.
5.2.2 AUTO TUNING
Press
to select Auto Tuning. If the TV use DVB-T or DVB-C tuner please refer to chapters 3.1 and 3.2; for Satellite (DVB-S) tuner
pq
please refer to chapter 3.3.
5.2.3 DISH SETUP
If you use Satellite as input source, the Dish Setup menu allow you to set you satellite and belonging settings as DiSEqC port and
LNB type. Afterwards you may start the Auto Tuning with the BLUE Scan button or Manual Tuning by selecting with INDEX button
the wanted transponder.
5.2.4 DTV MANUAL TUNING (IN DVB-T MODE ONLY)
Search and store programmes manually. Press
to select a Channel No., and then press ENTER to start the search. The search stops when a programme is found and this
Press
t
u
programme will be stored in the current channel position. Press MENU to exit.
5.2.5 ATV MANUAL TUNING (IN DVB-C MODE ONLY)
In the Channel menu, select ATV Manual Tuning and press ENTER to access. Highlight and press
other number), Sound System and Channel No.. Then select search and press ENTER to start the search. Press
search towards higher frequency. Press
found and this programme will be stored in the current channel position. If you want to stop the search, press MENU.
Sound Standard
Select the Sound standard.
Video Standard
Select the Video standard (Available: AUTO, PAL, NTSC, SECAM)
Current CH
Set the channel number.
Search
Start the channel search.
Fine-Tune
Adjust the frequency of the channel.
pq
to select an item. Press ENTER to select the submenus. Press MENU to exit the
t
u
to select DTV Manual Tuning. Then press ENTER to enter the sub-menu.
pq
for the unit to search towards lower frequency. The search stops when a programme is
t
11
to select event where you like to know more details. Press
to select the option you wish
pq
to select Storage To 1 (maybe
pq
for the unit to
u
Advertisement
Table of Contents
