Programming The Pbx In The Chicago Office - Panasonic KX-TDA0484 Getting Started

5.2 Programming the PBX in the Chicago Office

5.2 Programming the PBX in the Chicago Office
This section details the procedure to program the PBX in the Chicago office. Follow the same
procedure as you did for the PBX in the Los Angeles office, entering the setting values as
appropriate for the Chicago office.
Note
It is assumed that you have already installed the KX-TDA Maintenance Console (PC
programming software for the KX-TDA100/KX-TDA200 PBX) in your PC.
48 Getting Started
1. Start the KX-TDA Maintenance Console from
the Start menu.
2. a.
Type the Installer Level Programmer
Code (default: INSTALLER).
b.
Click OK.
3. a.
Click Connect
b.
In the next screen, type the system
password for installer (default: 1234).
c.
Click OK.
The program menu appears.
4. a.
Double-click Configuration.
b.
Double-click IP-GW Port.
Confirm that ports 1 and 2 are in service
(INS).
5. a.
Double-click CO & Incoming Call.
b.
Double-click CO Line Setting.
c.
Type the CO Name and assign an
unused Trunk Group Number to be
used for all VoIP gateway trunks (CO
lines).
d.
Click OK.
RS-232C or USB.