Advertisement
Disc Brake Calibration
Step 11
1.
Spin the wheel and listen
2.
If there's signs of rubbing,
for any scraping sounds.
loosen the screw with a
These indicates signs of
M4 hex key so the brake
rubbing.
caliper can move freely.
Adjust the clearance
between the brake pad
and disc until you can no
longer hear any sounds
when spinning the wheel.
16
Bike Assembly
3.
Tighten the screws.
Spin the wheel to
check for any sounds.
Rear Light Battery Replacement
1.
Unscrew the bolt on
2.
Insert a coin beneath
the back of the light to
the lid, spin the coin,
take it off.
and lift it open.
NOTE Replace with two CR2032 batteries.
!
3.
Replace both batteries.
Put the lid back on and
press the power button
to turn on the light.
Coin
17
Advertisement
