The Outdoor Plus SELF-CONTAINED UNIT Installation & Operation Instructions page 13

ASSEMBLY |
Water Feature Installation
WARNING
Never lift the unit by the Bowl, Tower, or Ring. This will damage the unit.
CAUTION
Before connecting the water system, ensure that the fountain is completely dry and free of
debris. Failure to do so can result in clogging or damage to the fountain's components
IMPORTANT
WARRANTY REQUIRMENTS: The Fire & Water Fountain must be constructed on a stable surface.
IMPORTANT
WARRANTY REQUIRMENTS: Adequate drainage is essential to prevent damage to surrounding
surfaces in your chosen location. Please note that The Outdoor Plus does not provide a warranty
against drips or leaks and assumes no responsibility for any damages. As the installer, it is your
responsibility to ensure that there is sufficient drainage to enable maintenance, repair,
winterization, or potential leaks from the water basin.
1. Install the pump, place it on a level surface below the water
level. For future maintenance, it is recommended to install
shut-off valves on both the inlet and outlet of the pump. The
installation area should have sufficient floor drainage and the
pump should be protected from excessive moisture. Ensure
that there is enough access area to service both the pump and
plumbing.
NOTE:
Hand Tighten Unions Only!
DO NOT
use a wrench or any adhesives or solvents!
DO NOT
use wrong sealant. Use Teflon or approved sealing
compounds for plastic. Wrong sealants can damage plastic.
New installations need plumbing inspection. City water pressure
is used for this test. Pressure should not exceed 40 PSI. Remove
air from the system when pump and filter are under pressure.
Be careful during the pressure test to avoid injury and voided
warranties.
INSTALLING THE WATER FEATURE:
13