Installation; Reversing The Door Swing - NewAir FlipShelf NWB060SS00 Owner's Manual

INSTALLATION

Before connecting the appliance to a power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Before operating your fridge for the first time, follow these steps:
• Remove the exterior and interior packing.
• Clean the interior surface of the unit with lukewarm water and a soft cloth.
• Place the fridge on a level surface that will be strong enough to support the unit
when it is fully loaded. To level your fridge, adjust the front feet located at the
bottom of the unit.

REVERSING THE DOOR SWING

This appliance has reversible door but is delivered with a right hinged door.
The left hinge kit comes with the unit (in the box), should you wish to reverse the hinge
on your unit.
1. Open the door to 90 degrees. Remove two screws from the door bottom right
hinge, slide door off hinge and pull door down to free it from the top hinge.
Remove boom right hinge relocated it to the left side.
2. Remove three screws from the top right hinge. NOTE: this top right hinge will be
replaced by a top left hinge located in the bag. Keep top right hinge in a known
location for future door reversal.
3. Remove the three screw hole covers from the top left.
4. Install the three screw hole covers at the top right where the original right hinge
was removed.
5. Install top left hinge with the three screws removed from the top right hinge.
6. Rotate the door with 180 degrees. Install the door by sliding it onto the top hinge
pin, then secure the bottom hinge pin using the screws removed in step 1.
•
Ensure the top of the door properly aligned with the top of the cabinet and that the
rubber gasket makes a good seal with the cabinet all the way around.
www.newair.com
EN
8