Assembly & Installation; Before Using Your Appliance; Installation Of Your Appliance - NewAir NWC023SS00 Owner's Manual

ASSEMBLY & INSTALLATION

BEFORE USING YOUR APPLIANCE

• Remove the exterior and interior packing.
Before connecting this appliance to the power source, let it stand upright
•
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
•

INSTALLATION OF YOUR APPLIANCE

• The appliance is designed for free-standing installation only.
WARNING: Do not store or install the appliance outdoors.
•
CAUTION: This appliance is designed for storing and cooling beverages and
•
drinks. Do not store perishable food, medicine or other medical products.
Place your Wine Cooler on a floor that is strong enough to support it when
•
it is fully loaded. To level the unit, adjust the front leveling legs.
For free-standing installation, leave 5 inches (127mm) of space around the
•
back and sides of the unit to allow proper air circulation to cool the
compressor and condenser.
NOTE: It is recommended that you do not install the appliance near an
•
oven, radiator or other heating source. Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption.
Don't install in a location where the temperature will fall below 64°F
(18°C). For best performance, do not install the appliance behind a cabinet
door or block the base grille.
Avoid locating the unit in moist areas.
•
Plug the Wine Cooler into an exclusive, properly grounded wall outlet. Do
•
not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should
be directed toward a certified electrician or an authorized service center.
www.newair.com
EN
11