ECD V-M.O.L.E. Solar Quick Reference Manual page 6

OPERATION - FRESH START
5
11) Enter the assembly information such as
part number, test product size, sensor
locations and a product image.
12) Click the Next command button.
13) Unwind the sensor leads and insert the
connectors into the M.O.L.E. ® Thermal
Profiler. Make sure to connect them to the
same channel(s) that were configured in
the wizard workflow.
14) Locate the thermocouple sensors on a
test solar cell.
When locating a thermocouple sensor on
a test solar cell, make sure it is slightly
curved
required to remain in place.
creating the proper tension