RapidSignage RS-200 Quick Installation Manual page 3

With DHCP networking:
If you want the RS-200 connect to a DHCP network, you need to directly connect with RS-200 first
and change the networking setting of the RS-200:
1. Click SystemConfig on the main page of RS-200, then click Network config Tab.
2. Double-click textbox of DHCP and make sure DHCP is turned on, then Click Apply.
3. Click Power tab, and click Reboot button to reboot the RS-200.
4. After reboot, the RS-200 IP address will be displayed on the boot screen.
Example:
Change the RS-200 into the diagram below:
AP / Router / Switch
RapidSignage - Rapid Digital Signage Deployments
www.rapidsignage.com