Jabra CRUISER2 hfs002 - In-Car Speakerphone Manual

PLEASE NOTE: Before using your new Jabra CRUISER2 speakerphone, charge and pair it with your selected Bluetooth® wireless technology enabled device.

ABOUT YOUR JABRA CRUISER2

GETTING STARTED

You should follow these three steps before using your speakerphone:

• Charge your Jabra CRUISER2
• Activate Bluetooth® on your mobile phone (refer to your mobile phone manual)
• Pair your Jabra CRUISER2 to your mobile phone

CHARGING YOUR SPEAKERPHONE

Use the USB cable to connect Jabra CRUISER2 to the car charger. The battery Status Icon will light up red while charging. When fully charged the icon will turn green. It takes approximately 2 hours to fully charge the speakerphone.

TURNING YOUR SPEAKERPHONE ON

Slide the on/off switch into the "I" position.

PAIRING THE SPEAKERPHONE WITH YOUR PHONE

1. First time pairing:
   When you turn on your Jabra CRUISER2 the first time it will be in pairing mode. You will hear a voice announcement guiding you through the pairing process.
2. Later pairing:
   Turn the speakerphone on. Press and hold the answer/end button untill you hear the announcement "Pairing mode" and the Bluetooth® indicator light begins to flash.
3. Activate Bluetooth® on your phone. Then set your phone to search for Bluetooth® wireless technology enabled devices and select Jabra CRUISER2.
4. Press 'OK' on the phone and if you are asked for a PIN code, confirm with PIN code 0000 (4 zeros).

USING YOUR SPEAKERPHONE

Answering or ending a call

• Tap the answer/end button on your speakerphone to answer/end a call.

Make a call

• The call will automatically transfer to your speakerphone*. If it does not, please tap the answer/end button on your speakerphone.

Redial last number*

• Double tap the answer/end button when the speakerphone is connected to your phone.

Adjust sound and volume*

• Tap the volume up and volume down buttons to adjust the volume level. (In FM mode your are not able to adjutt volume via the Jabra CRUISER2 – Use your car stereo).

Mute on/off

• Press the mute button to mute your microphone during a call and again to turn mute off.

Play Music*

• If your phone supports A2DP audio streaming then you can transfer music or any other type of audio to the Jabra CRUISER2.

ADDITIONAL FEATURES

FM transmit
You can transmit calls and music from your mobile phone to your car stereo using the CRUISER2. Press the FM button and set your radio to the announced frequency. If you need to change frequency press the volume up button while in FM mode to search for a new frequency.

Downloaded phonebook and caller ID*
The first time you connect your Jabra CRUISER2 to your mobile phone your contacts will be transfered automatically to your speakerphone. Up to 1.000 contacts per connected phone.

This allows the Jabra CRUISER2 to read out the name of the person who is calling you. If you add contacts to your mobile phone and need to update your downloaded phonebook your can start a manual update by a long press on the Mute button when the Speakerphone is turned on and connected to your phone.

Change voice guidance language
Enter pairing mode. When in pairing mode Press the FM Button until current language is announced. Tap volume up and down buttons to select a new language. When you have found your preferred language press the FM button again until your new language is announced.

* Phone dependent

www.jabra.com