Advertisement
USER GUIDE
Ice
ICE CUBE THICKNESS AND ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Ice is produced in layers resulting in a clear cube. Ice in
bin may develop surface frost which disappears when cube
is placed in liquid.
Ice cubes in any given batch will vary, so it is necessary to
choose cubes from the sample area for comparison when
making adjustments.
The ice cube thickness is factory set for best overall
performance. The factory setting is designed to maintain
an ice bridge of approximately 1/16" to 1/8" (1.6 mm to
3.2 mm) under normal conditions, resulting in a dimple of
approximately 1/4" to 1/2" (6.4 mm to 12.7 mm) in depth.
A fuller cube with less of a dimple results in a thicker ice
bridge. As the ice bridge becomes thicker, the tendency
for the cubes to stay together as a slab increases. A bridge
thicker than 1/8" (3.2 mm) may cause cubes to overfill the
ice bucket.
32 ice cubes are formed on a 4 x 8 slab during each cycle.
Each cycle takes approximately 15-20 minutes at the
default cube thickness (0).
7/8"
(22 mm)
7/8"
(22 mm)
First Use
DIMPLES
ICE BRIDGE
Your clear ice machine is preset to produce ice between
the optimal dimensions illustrated below:
Cube Details
1/4" TO 1/2"
(6.4 mm to 12.7 mm)
DIMPLE
Factory Default Setting - 0
THINNER BRIDGE
DEEPER DIMPLE
SHALLOWER DIMPLE
< 0
SETTING
Ice thickness adjustments are made using the control
panel as follows:
1.
To enter the thickness adjustment mode:
•
Press and hold
•
The display will switch to "0" to confirm the
thickness adjustment mode has been selected.
The factory setting is "0". Use
thicken the ice bridge, or
the ice bridge.
2.
Press
to confirm your choice.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the same area for comparison when
making adjustments.
23
1/16" TO 1/8"
(1.6 mm to 3.2 mm)
ICE BRIDGE
THICKER BRIDGE
> 0
SETTING
ULIN_0300_A
for 5 seconds.
to raise the setting and
to lower the setting to thin
Advertisement
