Troubleshooting Drivelines; Maintenance Record - Priefert FMX Operator's Manual

Section 7: Appendix
Problem
Wear of Yoke Ears
Bent/Twisted Yoke Ears
Cross Arms Broken
Accelerated Wear of Cross Arms
Separated Telescoping Tubes
Deformation of Telescoping Tubes
Accelerated Wear of Telescoping
Tubes
Accelerated Wear of Shield Bearing
Date
Drivelines Troubleshooting
Probable Cause
Clean Excessive Working Angle.
∗
Excessive Torque Peak or Shock Load.
∗
Excessive Torque Peak or Shock Load.
∗
Excessive Load.
∗
Excessive Extension of Driveline.
∗
Excessive Torque Peak or Shock Load.
∗
Insufficient Lubrication.
∗
Insufficient Lubrication.
∗

Maintenance Record:

Part
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
∗
Usage Hours
Remedy
Reduce working angle.
Make wide turns when possible.
Tight turns - disengage PTO and raise mower into
transport position.
Avoid overloading and engaging drive under load
Check PTO clearances with Tractor drawbar, etc.
Avoid overloading and engaging drive under load.
Do not exceed the speed or power limits indicated
in this manual.
Insufficient Lubrication.
Avoid excessive extension of driveline.
Check extension of drawbar hitch according to
this manual.
Avoid overloading and engaging drive under load.
Check function of torque limiter.
Check that driveline does not come into contact
with tractor or implement components during
movements.
Follow maintenance instructions on page 22.
Insufficient Tube Overlap - Refer to Driveline
Installation, pages 11-13.
Follow maintenance instructions on page 22.
Product weights may vary by approximately 5%.
Action Taken
31