Table of Contents
Advertisement
NLTroubleshooting
Malfunction
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum jerks after
program start.
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the spin
run.
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
High spin speed
rental is not
reached.
44
Cause and Troubleshooting
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system provides an extra rinse when
foaming is too high.
No error - no action required.
▶
The water is below visible range.
No error - no action required.
▶
▶ Do not fill the device with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
Insert in compartment is hidden.
→ "Cleaning the detergent drawer", Page
▶
34
The appliance is not leveled properly.
→ "Adjusting the device", Page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 16
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
Load recognition is active.
No error, no action necessary.
▶
Remark:The load detection can take up to 2 minutes.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
To iron lightlyis activated.
Select a suitable program for the type of fabric.
▶
Advertisement
Table of Contents
