Advertisement
Installation and Operation
Electrical Connection:
1. Loosen the ten M6 hexagon bolts on the driver housing Cover.
2. The entry hole of the driver housing is 3/4" NPT. Attach to suitable conduit.
3. Run the wire from outside through the conduit and the entry hole of driver housing, and then connect it to
the Terminal Block.
4. Re-attach the housing cover and tighten it with the ten M6 hexagon bolts at torque value 7 N-m.
Product Size
342mm /13.5in
Wall/Ceiling/Floor Mounting Bracket
5. The mounting bracket is for the use of wall/-
ceiling/floor mounting.
6. Position the mounting bracket and attach it
with two pairs of M6 and M8 hexagon bolts, and
spring lock washers.
7. Secure the wall/ceiling/floor mounting bracket
to the structure. (Figure 1)
8. The fixture can be adjusted up and down by
45° on wall/floor position only. (Figure 2)
9. The fixture can be adjusted facing down 90°
from vertical = Lens horizontal facing down on
ceiling position. (Figure 3)
Pendent Type
10. Attach 3/4" size pipe with M5 screws. (Figure 4)
Servicing
To avoid personal injury, disconnect power to the fixture and allow it to cool down before performing mainte-
nance.
Perform visual, electrical, and mechanical inspections on a regular basis. The environment and frequency of
use should determine this. However, it is recommended that checks should be made at least once a year.
The external glass should be cleaned periodically to ensure continued performance. Clean the glass with a
clean, damp, non-abrasive, lint-free cloth. If this is not sufficient, use a mild soap or a liquid cleaner. Do not
use an abrasive, strong alkaline, or acid cleaner as damage may occur.
Inspect the cooling fins on the fixture to ensure that they are free of any contamination (i.e. excessive dust
build-up). Clean with a non-abrasive cloth if needed. Mechanically check to make sure all parts are properly
assembled.
Electrically check to make sure that all connections are clean and tight.
LDPI, Inc. 1-800-854-0021 Web: www.ldpi-inc.com E-mail: sales@ldpi-inc.com
271mm/10.7in
Wall Type:
The Angle mark
Ceiling Type:
200mm/7.9in
140mm/5.5in
F ig. 1
Floor Type:
Angle 0-180° Adjustable
F ig. 2
Pendent Type:
F ig. 3
R 5.5
Angle 0-180°
Adjustable
M5 cross recess pan head screw
F ig. 4
Page: 2
REV: 09.14.20
Advertisement
