Table of Contents
Advertisement
Quick Links
FIRES UP TO
FIRES UP TO
FIRES UP TO
FIRES UP TO
12
12
12
METERS!!
METERS!!
METERS!!
METERS!!
TIRE JUSQU'¤ 12 M˚TRES
TIRE JUSQU'¤ 12 M˚TRES
TIRE JUSQU'¤ 12 M˚TRES
TIRE JUSQU'¤ 12 M˚TRES
FEUERT BIS ZU 12 METER
FEUERT BIS ZU 12 METER
FEUERT BIS ZU 12 METER
FEUERT BIS ZU 12 METER
DUAL BARREL
BLASTER
LARGE EASY
STEERING WHEELS
OWNER'S MANUAL
BLASTER SCOOTER
3 WHEEL TILT&TURN SCOOTER
MODEL NO.: M5
2 HEIGHT
ADJUSTABILITY
SHOCK ABSORBING
RUBBER GRIPS
STANDARD NERF
CLIP
PROTECTIVE EQUIPMENT SHOULD BE
WORN. NOT TO BE USED IN TRAFFIC.
L'ÉQUIPEMENT DE PROTECTION DEVRAIT
ÊTRE PORTÉ. NE PAS UTILISER DANS LA
STEEL FRAME
CIRCULATION.
SOLLTE GETRAGEN WERDEN. NICHT IM
VERKEHR VERWENDEN.
50 KGS / 110 LBS MAX.
DO NOT AIM AT EYES OR FACE.
TO AVOID INJURY: USE ONLY
DARTS DESIGNED FOR THIS
X6 C
PRODUCT. DO NOT MODIFY
DARTS OR DART BLASTER.
BATTERIES
BE SAFE, ALWAYS WEAR A
NOT INCLUDED
HELMET AND OTHER PROTEC
TIVE GEAR.
6+
AGE
ANS
EDAD
EASY STEP
BRAKE
TEXTURED MOLDED
SURFACE DECK
WARNING!
WARNUNG!
SCHUTZAUSRÜSTUNG
CAUTION!
Advertisement
Table of Contents
Related Manuals for Nerf M5
Summary of Contents for Nerf M5
- Page 1 TO AVOID INJURY: USE ONLY OWNER’S MANUAL DARTS DESIGNED FOR THIS X6 C PRODUCT. DO NOT MODIFY BLASTER SCOOTER DARTS OR DART BLASTER. BATTERIES BE SAFE, ALWAYS WEAR A NOT INCLUDED HELMET AND OTHER PROTEC TIVE GEAR. 3 WHEEL TILT&TURN SCOOTER MODEL NO.: M5...
- Page 2 7. Only one child may ride on the Nerf Blaster Scooter at any one time. 8. Never allow your child to ride the Nerf BlasterScooter at dusk or at night. 9. The Nerf BlasterScooter must not be used on wet, oily, sandy, dirty, icy, rough or uneven surfaces.
- Page 3 PARTS LIST Adult assembly required. Warning! Not to be used by children under 36 months due to small parts while unassembled. Choking Hazard. Blaster Fastening Bolt Battery Cover with 4 screws Clip (2 pieces) 6 C Cell Batteries Required (Not Icluded) Tip: Please verify that all pieces are included prior to beginning assembly.
- Page 4 ASSEMBLY Step 1: Step 2: Remove the bolt from the bottom of the Push the button and insert the stem blaster, then slide the blaster into the cradle. into the base. Replace the bolt from underneath the cradle and tighten to lock the blaster in place. Step 3: Step 4: X6 C...
- Page 5 HOW TO ADJUST THE HEIGHT The handlebar can be locked into place at 2 di erent heights. Please make the following adjustment to reach required height. Open the Quick Release Lock, press the locking button, adjust the handlebar to a suitable height, and then close the Quick Release Lock.
- Page 6 FIRING Press and hold either Trigger button until you hear the motors engage and the darts re, then release the button to stop the blasts. Keeping the trigger buttons pressed will re the darts in rapid re mode continously. Trigger Button. LOADING AMMO Load DARTS into the QUICK RELOAD CLIPS.
- Page 7 CLEARING JAMS If any dart becomes jammed, open the Jam Clearing Door and remove the darts that are stuck and replace in the Clip. Note: The Blaster will not operate unless the Door is fully closed. STORING YOUR BLASTER IMPORTANT: BATTERY INFORMATION NOTE: Do not store blaster ready to re.
- Page 8 Made in China Designed in U.S.A © 2019 Flybar, Inc. Manufacturer: Flybar, Inc, New Jersey USA. www.flybar.com 845-647-8400 HASBRO and its logo, and NERF are trademarks of Hasbro and are used with permission. © 2019 Hasbro. All Rights Reserved.
Need help?
Do you have a question about the M5 and is the answer not in the manual?
Questions and answers
Just received as a gift and took out of the box and trying to get the blaster part connected to the scooter. It has a grey button on the front. The nerf blaster will not click in. Please help, it is a birthday gift.
The manual does not provide information on how to connect the Nerf M5 blaster to the scooter or what to do if the grey button does not click in.
This answer is automatically generated