Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Full Spectrum Laser MUSE MOPA
Summary of Contents for Full Spectrum Laser MUSE MOPA
-
Page 2: Safety Warning
Safety Warning: Diagrams: Do not leave your machine unattended. Avoid using machines made of carbon or that contain carbon components. Laser head Assembly Wifi Plug Ethernet Always keep a fire extinguisher and first aid kit nearby. Port Do not attempt to access any electrical areas while the Wifi Dongle Rotary machine is on. -
Page 3: Connecting To Internet
Connecting to Internet: Assembly: Connect Via Router (Recommended): M5 hex To establish a reliable link to RE3, it is recommended to connect the Fiber Galvo to the router. The Fiber Galvo is equipped with an ethernet cable that M4 hex should be plugged into the ethernet ports of both devices 2- m5 screws... -
Page 4: Touchscreen Interface
Touchscreen Interface: Home The Home screen displays important information such as the device's Network ⇨ Wi-Fi IP address, the QR Code for RE3, and controls for the laser head. Enables users to connect to a Wi-Fi network. Job History The Job History icon provides easy access to previous projects. Mobile Version Users can select the file and view its contents, or choose to re-run the A mobile version of the device is accessible by either scanning... - Page 5 Focusing: Manual Focus Autofocus The focal length of the lens determines the distance between your laser head and the To autofocus your machine, you need to retrieve your April tag card first. Ensure that the side material. Refer to the chart below for the required distance for each of our lenses. of the card which says "Focus Card V1.2"...
-
Page 6: Lens Replacement
Focusing: Lens Replacement: Dual Diode: Lens Collar Camera Lens 1. Remove any objects or work pieces from underneath the lens work area. Ensure laser head is in a reachable position to remove lens. 3. Place the lens cap onto your lens to protect the lens from potential damage. 4. -
Page 7: Lens Calibration
Lens Calibration: Once the Laser Tools page is loaded, locate the Laser Focus and Lens Calibration section. Ensure that the correct lens size is saved in the lens section. If the wrong lens setting is saved, then all subsequent calibrations will need to be redone. 2. - Page 8 Mark Adjustment: Preview Adjustment: After confirming that the mark adjustment is accurate, proceed to mark a new square by selecting the "Mark Square" button. 1. Without moving the previously engraved material, press the "Preview Square" button. 2. Make use of the adjustment buttons to align the tracing made by the red dot precisely with the To verify the success of the lens calibration process, run the mark adjustment.
- Page 9 Focus Tag Calibration: Ensure that your machine is properly focused before starting the calibration process. Take note of the Z-stage coordinates displayed on the Main Unit screen to ensure accurate calibration. Navigate to the Laser Tools page and locate the Galvo Autofocus Calibration section. Select the Autofocus Mode. AprilTag: Choose the AprilTag option to calibrate the Focus card.
-
Page 10: Troubleshooting
Project Procedure: Troubleshooting: Q: What should I do if my laser isn't marking? A: Check if the laser is properly focused. If the machine is not at the right height, it won't Connect to Software engrave. Refocus the laser head after changing to a new material. Still having difficulties, make sure that your material is compatible with your laser engraver.
Need help?
Do you have a question about the MUSE MOPA and is the answer not in the manual?
Questions and answers