Connectivity; Pairing Instructions - Miele PDR 511 HP Quick Start Manual

Pairing instructions

Follow the steps below to connect the tumble dryer to your network.
Opening the Supervisor level
Switch on the appliance by turning the rotary control from the  position to any other

position.
Open the door of the tumble dryer.

Press and hold the / sensor control while you close the door.

Keep pressing the / sensor control until / flashes and then lights up per-

manently.
You are now in the Supervisor level.
Establishing the network connection via WPS
On the supervisor level, select  using the  or  arrow buttons.

Then select the internal communication module  using the  or  arrow buttons.

Confirm with the / sensor control.

Restart the tumble dryer by turning the rotary control to the  position.

Switch the appliance on again by turning the rotary control from the  position to any

other position.
Press and hold the left arrow button  until  appears briefly on the display.

A timer will then start.
Press the WPS button on your router within the specified time.

The network connection via WPS is being established.
The appliance is now successfully connected.
Establishing the network connection via soft AP
On the supervisor level, select  using the  or  arrow buttons.

Then select the internal communication module  using the  or  arrow buttons.

Confirm with the / sensor control.

Restart the tumble dryer by turning the rotary control to the  position.

Switch the appliance on again by turning the rotary control from the  position to any

other position.
Press and hold the  sensor control until  appears briefly on the display.

A timer will then start. The tumble dryer now opens the soft AP.
Establish the connection with the Device Connector in Miele MOVE.

Once a connection is established, dots flash in the  word.
Then continue with the Device Connector in Miele MOVE.
en - Connectivity
107