Relay PW250 User Manual page 14

Please do the following settings:
Then you can program the values for the serial communication after startup in the sheet "Default Serial
Settings" (baudrate, data bits, parity, flow control). A click at „OK" generates the virtual port and then it can be
used in your M-Bus software. Please select the respective port (VSP name) in your software as the
communication interface. Now the installation is completed. You can change the settings of the device and
the COM port using the DS manager respectively the VSP manager at any time. You can also change the
settings of the device server and check its routing state after first setup using a web browser connected to the
assigned IP address. The required password for the login is empty on delivery.
PW250 · User Manual Version 1.1 – 11 / 2019
PW250
Change
marked values
Browse for DS:
Select the
device server
14