2.1 Mounting The case of the PW250 can be attached to a wall with four screws. The drill pattern is rectangular (180 mm horizontal, 180 mm vertical). The drillings shall have a diameter of 5 mm. You can alternatively fix a special rail holder to the case to enable the mounting on a rail of the type TS 35 (Accessory: GHZ TSH35-2).
10/100MBit RJ45 Ethernet socket for network connection RS232 RS232C D-SUB9 socket USB Device USB connector of the internal USB-to-RS232 converter (FTDI). Cable glands for power supply, M-Bus, RS232C, RS485 and M-Bus IN PW250 · User Manual Version 1.1 – 11 / 2019...
You can find all other patterns in the online help of the DS Manager (F1-button) in the chapter “Firmware Manuals / Device Server Application Firmware / Status LED Signals (Red = Green / Green = Yellow). PW250 · User Manual Version 1.1 – 11 / 2019...
DDC or a PC to read the connected meters by use of an M-Bus software (not in scope of delivery). The PW250 can also be used as a Repeater for extension of M-Bus networks relating to the cable length and number of meters.
3.4 Repeater interface The PW250 can be used as a so-called Repeater, as a network extension for existing M-Bus systems, if the maximum number of meters or the maximum cable length has been exceeded for the installation. Up to 250 devices and up to 4km cable (1 x 2 x 0.8 JYSTY) at 2400 baud transmission speed can be connected to a...
3.5 USB interface The USB device port of the PW250 is as a USB 2.0 connector type B available on the front of the housing. Please use a USB cable with a type A plug on one end and a type B plug on the other side (not supplied) to connect a PC.
PCs in that network. This requires the so-called “Tibbo Device Server Toolkit” to be installed on that PC. With this software the Ethernet interface is configured in the PW250 and a virtual COM port is set up.
(32-Bit Windows) or tdst_5-09-12-x64.exe (64-Bit Windows) TDST = Tibbo Device Server Toolkit, 5-09-12 = Version 5.09.12 dated August 2014) After a reboot of the PC the installation of the drivers and software tools is completed. PW250 · User Manual Version 1.1 – 11 / 2019...
Please select the device which you want to configure and click on the button “Settings”. Then you see the settings of the device which you shall change according to the following pictures. You can get help for the DS Manager with F1 key. PW250 · User Manual Version 1.1 – 11 / 2019...
Page 12
PW250 Recommended settings: Change values marked with an arrow Stores settings and restarts the device PW250 · User Manual Version 1.1 – 11 / 2019...
You also don´t need a virtual port in the bridge mode (two device servers connected together, i.e. one TCP001 (serial device server) to the PW250. Please start the Tibbo – DS Manager (Start – Programs – Tibbo – Tibbo Device Server Toolkit –...
Page 14
IP address. The required password for the login is empty on delivery. PW250 · User Manual Version 1.1 – 11 / 2019...
Repeater (M-Bus IN) Terminals 3 pairs screw terminals for M-Bus, 3-pin screw terminal for RS232C, each 1 pair screw terminals for RS485 and Repeater, 4-pin screw terminal for power supply PW250 · User Manual Version 1.1 – 11 / 2019...