Sharp LC-43Q3000U Quick Start Manual page 2

Next, select USB Firmware Upgrade and then select OK.
6.
Figure 5. USB Firmware Upgrade tab
The update process will start as shown below.
DO NOT remove the USB thumb drive or power off the TV during this
Figure 7. Dialogue Message not to remove the USB
Wait for 2 minutes to allow the software update process to finish. Do not interact with
7.
the TV during this process. Once it's complete, the TV will power off.
Remove the USB thumb drive from the back of the TV.
8.
9. Power On the TV.
Go to "SettingsAbout TV", and make sure the Version is
10.
then repeat these steps again.
Figure 8. Version Number
Note
Normally, there is no need to do a factory reset after the USB software update. However, if the issue persists,
then go to Settings  About TV Restore To Factory Default OK
Figure 9 About TV
If you have any questions or concerns, then give us a call at 1-888-935-8880 and provide your
first and last name or telephone number.
SHARP Firmware Instructions
Figure 6. OK tab to select
Figure 10. Restore to factory default
process.
"V0000.01.01.I1204".
Figure 11. OK to restore the Factory Default
If it is not,
Page 2 of 2