Intex Krystal Clear C2500 Owner's Manual page 8

POOL INLET - NOZZLE & PLUNGER VALVE SETUP ( OPTIONAL )
1. In a counter-clockwise motion unscrew plunger valve
union from the inlet threaded air connector (19) (see
drawing 5). Be careful not to lose the step rubber
washer (22). Place the plunger valve on the ground
in a safe place.
2. In a counter-clockwise motion unscrew the strainer
nut (12) from the inlet threaded air connector (19).
Leave the flat washer (13) on the connector (19).
3. Install the nozzle and plunger valve at the upper
position of the pool inlet. From the inside of the pool
liner insert the nozzle union (15 & 19) into one of the
pre-cut holes with the washer remaining on the
connector to be placed against the inside of the
liner wall.
4. Before assembly, lubricate the threads with a
petroleum jelly. Then, with the flat side of the strainer
nut (12) facing the outside wall of the liner in a
clockwise motion screw the strainer nut (12) back
onto the inlet threaded air connector (19) (see
drawing 6).
5. Finger tighten the adjustable pool inlet jet nozzle (15)
and the strainer nut (12) onto the inlet threaded air
connector (19).
6. Grasp the plunger valve assembly. Make sure the
step washer (22) is in place.
7. Screw the air jet valve (18) over the inlet threaded air
connector (19). NOTE: Make sure the air jet valve is
securely tighten and facing up. In a clockwise motion
screw the plunger valve union back onto the inlet
threaded air connector (19) (see drawing 7).
8. In a clockwise motion turn the plunger valve handle
to close position. Ensure the plunger valve is
securely closed. This will prevent water from flowing
out during filling of the pool (see drawing 8).
9. Adjust the direction of the nozzle head pointing away
from the pool outlet for a better circulation result (see
drawing 9).
10. The pool liner is now ready to be filled with water.
Consult the above-ground-pool owner's manual for
the filling instructions.
SAVE THESE INSTRUCTIONS
(110GS) MODEL 634RC FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 06/13/2022
12
NOTE: Do not cover the air jet
valve (18) with the valve cap (20)
under normal situation or when
the pump is operating. See
Troubleshooting Guide section
for more details.
110
English
GS
5
2
1
6
INSIDE
LINER WALL
13 19 15
7
18
1
2
8
INSIDE
LINER WALL
9
Pool
WATER
FLOW
Page 7