Cooper Lighting Solutions Invue VWM Vision Wall Medium Installation Instructions Manual page 4

Installation Instructions - VWM Vision Wall Medium
Embedded Mounting Kit
1. The embedded mounting kit is intended for use when it
is desirable to cast the mounting bracket into a poured
wall. For orientation to the junction box (Figure 2.)
2. Make sure all power is off.
3. Pull the power supply wires through the junction box
and through the center hole of the embedment plate,
leaving 6" for connections.
4. Using the two screws supplied with the junction box,
attach the plate to the junction box, with gaskets and
studs facing away from the wall. (Figure 11.)
5. Position the assembly on the wall.
Door
Figure 9.
4
COOPER LIGHTING SOLUTIONS
IB514020EN Installation instructions
Mounting Studs
Figure 10.
Figure 11.
3 1/2"
[88.9mm]
Figure 12.
Thread Power Feed
lines thru here
6 3/8"
[161.2mm]