Advertisement
Available languages
Available languages
8.
Carefully slide the fixture down the keyhole, taking care
not to damage the gaskets.
9.
Tighten the screws or nuts (Depending on mounting
type).
N
ote:
Do not caulk around the fixture.
10. Have a qualified electrician make the power
connections.
11. Push the supply wires back through the center hole and
down in the rear fixture cavity.
12. Swing the reflector assembly back up and latch into
position.
13. Install the door and four 1/4-20 screws. Tighten the
screws diagonally opposed.
Standard Mounting Kit
1.
The standard mounting kit may be mounted to any
standard, embedded, 4" junction box. It is not for use
with a surface mounted junction box. For orientation of
fixture to the junction box. (Figure 4.)
2.
Using the two screws supplied with the junction box,
install the mounting plate as shown. The 5/16-18 studs
should be facing away from the wall and above the
center of the bracket (Figure 5.). For rough or uneven
surfaces, sealant must be applied (by others) between
the rear mounting plate gasket and the mounting
surface (wall).
3.
In addition to the screws supplied with the junction
box, the unit must be supported by 1/4" anchor screws
(supplied by others) installed through the four holes
provided. (Figure 6.)
Apply Sealant
as Required.
See Note #2.
Figure 5.
Installation Instructions - VWM Vision Wall Medium
3 1/2"
[88.9mm]
Figure 6.
Figure 7.
Led Assembly
Locking
Screw
Figure 8.
COOPER LIGHTING SOLUTIONS
6 3/8"
[161.2mm]
IB514020EN
Installation instructions
3
Advertisement
