Advertisement
Completing the installation
19
Install mortise case faceplate
1 Secure the mortise case faceplate to the mortise case
with the faceplate mounting screws.
2 Check the lock for proper operation.
20
Install strike box and strike plate
1 If the door jamb has not been mortised for the strike box
and strike plate, perform these steps:
a On the door jamb, locate the horizontal centerline
of the strike (3/8" above the centerline of the
lock), as well as the vertical centerline of the strike.
a Mortise the door jamb to fit the strike box and
strike plate.
a Drill the holes for the screws used to install the
strike box and strike plate.
2 If the strike box has a filled area, orient the strike box
so that the filled area is down.
3 Insert the strike box into the mortise in the door
jamb. Place the strike plate over the strike box and
secure the strike with the screws provided.
4 Check the position of the auxiliary bolt against the
strike plate (or the filled area of the strike box).
Note: The recommended gap between the door and
jamb is 1/8"
Installation Instructions for Electronic Stand-Alone Mortise Locks
Figure 19 Installing the mortise case faceplate
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
Outside of door
Figure 20 Installing the strike box and strike plate
Mortise
case
faceplate
Faceplate
mounting
screws
Strike box with
filled area
Filled
area
Strike
plate
Strike
box
11
Advertisement
