Page 1
OUTDOOR PORTABLE HEAT PUMP WITH FRAME ENGINEERING, INSTALLATION AND SERVICE MANUAL OCEANAIRE, Inc. 1731 Wall Street, Suite 100 Mount Prospect, IL 60056 OA-EISM-OPACH4212- REV. 04062023 (847) 583-0311 oceanaire-inc.com...
Page 2
OPACH4212 unit. As with all commercial air conditioning equipment, it is recommended to have the OPACH4212 sized and installed by a licensed specifying engineer and contractor, in accordance with all local and state codes.
With 38,000 BTUH of Heating capacity, and 7 KW Auxiliary Electric Heat, the OPACH4212 can heat a defined space as well. The unit is designed for industrial applications. The heavy-gauge 2” x 2” powder coated steel frame safeguards the unit from its surroundings, and aids with handling and storage.
Supply: 1 x 12” Dia. Duct Collar Return: 2 x 12” Dia. Duct Collar with integral Return Air Filter Frame Filter: (1) 14 x 25 x 1, Pleated DRAIN P-Trap with 3/4” Male Garden Hose Connector Page 4 OA-EISM-OPACH4212- REV. 04062023...
Page 5
MAIN (50 AMP - 250VAC) BREAKER BOX THERMOSTAT STORAGE COMPARTMENT SUPPLY AIR RETURN AIR (2 X 12-INCH COLLAR) (12-INCH COLLAR) OPACH4212 LEFT SIDE CONTROLS ACCESS PANEL THERMOSTAT CABLE RECEPTACLE EVAP BLOWER ACCESS PANEL OPACH4212 REAR NOTE: THE AUXILIARY ELECTRIC HEATER SAFETY BREAKER IS...
Page 6
CONNECT ONLY TO POWER SOURCE AS SPECIFIED ON UNIT NAMEPLATE 1. Set up the OPACH4212 unit on a level surface. Make sure that there are no objects on top of the unit. Maintain an operating clearance of 3 feet minumum on all sides of unit.
Page 7
OPACH4212 CONTROLS COMPRESSOR TRANSFORMER CONTACTOR THERMOSTAT CAPACITOR HIGH VOLTAGE CABLE DEFROST RECEPTACLE POWER BLOCK CONTROL AUX. HEATER CIRCUIT BREAKER (40A) EVAPORATOR BLOWER MOTOR EVAP MOTOR POWER CONNECTOR - PLF (SEE NOTE 2 ON WIRING DIAGRAM) Page 7 OA-EISM-OPACH4212- REV. 04062023...
Page 9
Powering and Starting the Unit - Follow the Instructions on Page 6 of this manual. 1. Make sure that the power supplied to the OPACH4212 unit matches the power shown on the unit nameplate, and that all power connections are correct and secured.
Model Number: MODEL: OPACH4212 TROUBLESHOOTING GUIDE OPACH4212 Troubleshooting Guide Start Up Thermostat Display will not Illuminate Check Incoming Power. Correct power supplied to unit. Check MAIN Breaker and reset it, if needed. Check the Thermostat Cable Connection at the unit. Re-seat the connector.
LIMITED WARRANTY The Manufacturer (Oceanaire, Inc.) warrants to the original owner that the Product will be free from defects in material or workmanship for a period not to exceed one (1) year from date of installation. If upon examination by the Manufacturer, the Product is shown to have a defect in material or workmanship during the warranty period, the Manufacturer will repair or replace, at its option, that part of the Product which is shown to be defective.