Chicco CRESCENDO UP Instructions For Use Manual page 11

not been damaged during trans-
portation. In this case, do not use
and keep out of reach of children.
• The highchair shall only be opened,
adjusted and closed by an adult.
• Make sure that the person using
the highchair knows exactly how it
functions.
• Make sure your child is at a safe dis-
tance when opening and closing
the product.
• To avoid crushing, ensure that the
child's hands are far from interlock-
ing components while the tray is
being attached to the seat.
• Never move the highchair with
your child seated in it.
• Do not allow other children to play
unsupervised near the highchair, or
allow them to climb it.
• Do not use the highchair for more
than one child at a time.
• Do not leave small objects on the
highchair that can be swallowed
by children.
• Do not place the highchair near
windows or walls where strings, cur-
tains or other objects could be used
by the child to climb or pose chok-
ing or strangling hazards.
• Do not place the highchair near
windows or walls to prevent your
child from affecting the stability of
the highchair by pushing their feet
against the wall and causing it to
topple over.
• Always place the highchair on a
horizontal, stable surface when the
child is seated in it. Never place the
highchair near stairs or steps or on
carpets.
• Bags or weights must not be placed
on the tray or hung on the high-
chair frame, as they might affect
the stability of the highchair.
• If the highchair is exposed to direct
sunlight for a long time, allow it
to cool down before placing your
child in it.
• Prolonged exposure of the high-
chair to direct sun light may cause
the colour of the materials and fab-
ric to fade.
• When not in use, the highchair
must be kept out of reach of chil-
dren.
• Do not use components, replace-
ment parts or accessories that have
not been supplied or approved by
the manufacturer.
• Do not open or close the highchair
when your child is sitting in it.
• WARNING! Keep the tray out of
reach of children when it is not in
use.
ASSEMBLY
1. Open the frame, distancing the rear legs until the end posi-
tion is reached (Fig. 1).
2. Turn the lever "A5" and press the button "A4" to withdraw the
pins located on the sides of the seat (Fig. 2A-2B).
3. Keeping the lever and the button pressed, position the hori-
zontal plane then release the lever and the release button
allowing the pins to connect to the appropriate holes on the
rear leg (Fig. 3).
WARNING: Having completed this step, press lightly on the
seat area to ensure it is properly fastened.
4. Press the release button "A3" located under the seat and, at
the same time, turn the cover "A2" anticlockwise (Fig. 4A-4B).
Next, remove the cover, placing your fingers through the un-
derlying holes for leverage (Fig. 5).
5. Position the chair "C" as in the figure, inserting the attach-
ments "C1" in the appropriate sites on the seat area "A1" (Fig.
6).
6. Next, turn the chair clockwise so that it locks to the seat area
until you hear a "click" (Fig. 7).
WARNING: Make sure that the chair is properly fastened to the
base and that the seat area is properly attached before using
the product (Fig. 8).
STROLLER SAFETY HARNESS
WARNING: The safety harnesses and the crotch strap must be
used to guarantee the child's safety.
The chair has a 5-point safety harness ("C3").
7. Release the safety harnesses by pressing on the central but-
ton found on the crotch strap (Fig. 9).
8. Insert the baby's legs into the two leg openings found on
the chair.
11