User Guide Performa UF 269 / LOGIX 869
4.2.
History
To access the recorded information, press simultaneously
Use
and
to navigate.
5 .
Operation
5.1.
Recommendations
• Use only regenerate salts designed for water softening EN973;
• for optimal system operation, the use of clean salt free from impurities is recommended (for example salt pellets);
• do not use ice melt, block, or rock salts;
• the sanitizing process (both with liquid and electrochlorination) introduces chlorine elements which may reduce the life of
the ion exchange resins. Refer to the technical guides for resins in common use, providing necessary checks on the system.
5.2.
Manual regeneration
Mandatory:
The controller must be in service in order to enable this procedure.
Note:
The unit returns to normal operation if no buttons are pressed within 30 seconds.
Immediate regeneration
A
Press and hold
for 5 seconds.
→
Camshaft starts rotating to cycle C1.
Manual delayed regeneration
B
Press
.
→
The regeneration will start on the scheduled date
6 .
Maintenance
Mandatory:
Cleaning and maintenance shall take place at regular intervals in order to guarantee the proper functioning of the
complete system, and be documented in the Maintenance record book.
Mandatory:
The maintenance and service operation must be done by qualified personnel only. Failure in respecting this may void
the warranty.
7 .
Troubleshooting
Please follow this procedure for any technical support:
A
Collect the required information for a technical assistance request.
→
Product identification (see 2.1. Serial label location, page 5 and Original settings, page 2;
→
Error number displayed on the controller;
B
Contact your local dealer who installed this device (see contact details on last page).
→
Also call him if the water tastes salty, if the water is not softened or if there is no salt consumption.
8 / 44
and
for 5 seconds when the controller is in service mode.
Note:
To cancel: press and hold
Note:
To cancel: press
and
for 5 seconds.
again.
Ref. MKT-UG-056 / A - 12.04.2023