Table of Contents
Advertisement
MAINTENANCE
'Clean and inspect your tool every time you use it'
The employer and tool operator are responsible for assuring that the tool is kept in safe working order.
Furthermore only service personnel trained by the manufacturer, distributor, or employer shall repair the tool.
CAUTION Always remove the air supply before commencing any cleaning or inspection.
Wipe tool clean and inspect tool for wear or damage. Use non-flammable cleaning solutions to wipe the tool.
Never soak the tool in these solutions as they can cause internal damage.
Always ensure that all of the screws are kept tight as loose screws can cause injury or can damage the tool.
Tools requiring lubricant: If the tool is used without an in line lubricant then be sure to put in about 3 drops of
lubricant at the start of each workday and 3 drops for every 1,000 fasteners fired there after.
Tools shall be repaired or equipped only with parts or accessories that are supplied or recommended by the
tool manufacturer / supplier.
NEVER use a tool that requires repair work.
Complete * Schaumburg, IL 60173 * Phone: 888-392-9947
8
Advertisement
Table of Contents
Troubleshooting
