Making A Recording - Panasonic SA-XR55 Operating Instructions Manual

Sound quality/Sound field/Convenient functions
Adjusting the subwoofer level
You can adjust the volume of the subwoofer while
listening to a source.
Sound can be distorted if you raise the volume while
the subwoofer level is high. Reduce the subwoofer
level if this occurs.
Muting
To mute the volume.
Multi-source re-master
This original feature boosts the frequencies of the
higher harmonics that are lost during recording due
to compression.
You can enjoy a full, more natural sound with this.
Dimmer
Dim the display for better viewing in a darkened
room.

Making a recording

You can record to a tape deck connected to TAPE REC (OUT) or a DVD recorder connected to DVD RECORDER OUT.
See the recording unit's operating instructions for details on how to prepare it for recording.
SPEAKERS
POWER
A B DUAL AMP BI-AMP BAND PRESET TUNE
VCR 2
VIDEO IN L AUDIO IN R
Note
• You cannot record a source connected through a digital terminal.
• When recording from a TV/STB, DVR, CD or DVD ensure the source is connected through the corresponding analog terminals and "ANALOG " input
is selected. (ápages 4, 5, 9, 10 and 13)
• With a tape deck, you can record any analog source except TAPE.
• With a DVD recorder, you can record any analog source except DVR.
• When you select DVD ANALOG 6CH mode, only sound from the front left and right channels is recorded.
20
Select.
Select.
• Dolby Pro Logic
• If you make any settings in "Speakers combination settings", "Surround back speaker
settings" or "Speaker settings" (ápages 12, 21) when using multi-source re-master, multi-
source re-master is canceled.
Multi-source re-master cannot be used in the following cases.
• When input signal is DTS 96/24, PCM with sampling frequencies of 192, 176.4, 96 or 88.2 kHz.
INPUT SELECTOR
INPUT SELECTOR VOLUME
MULTI
CONTROL ENTER
CANCEL
DOWN UP PHONES
• You can make fine settings by pressing [TEST] then adjusting
the output level. (ápage 13)
• You cannot adjust the subwoofer level if "DVD ANALOG 6CH"
is selected.
• Select "SW --- " to stop output.
Factory setting: SW 10
• "MUTING IS ON " scrolls on the display while the volume is
muted.
• Muting is canceled when the power is turned off.
n To cancel: Press again
EFFECT 1: For fast tracks (pop and rock)
EFFECT 2: For tracks with a variety of tempos (jazz)
EFFECT 3: For slow tracks (classical)
EFFECT 4: For compressed audio signals
OFF: The re-master processing is off (factory setting)
, DTS NEO:6 and SFC are canceled when using multi-source re-master.
n To cancel: Press again
áRefer to page 19 for adjusting the brightness of the display.
1
Select the source to be recorded.
2
Begin recording.
Follow your recording unit's operating instructions.
3
Start the source to be recorded.
Follow your equipment's operating instructions.
INPUT SELECTOR