Surface Mounting - San Jamar SAF-T-ICE Instructions For Use Manual

Mount Guardian System
™
AND suction cups.
Wire Mounting Hanger
Optional Drain Cap (not shown)
Using Suction Cups:
Secure suction cups onto mounting bracket and press Guardian System
for extended periods based on the type and texture of surface.
For best results: Use wire hanging bracket and suctions cups. Make sure mounting surface is clean and dry. Slightly moisten
suction cup surfaces before use.
Removable drain cap gives the option
of allowing excess water to drain out
or be retained. Use of the drain cap
is recommended for exterior mounting
applications where excess water may
accumulate on a floor causing a safety
hazard.
INSIDE BIN MOUNTING
into place using either the mounting bracket or suction cups or for best results mount with wire hangers
Suction Cups
Optional Drain Cap (not shown)

SURFACE MOUNTING

Mounting Screws
(not included)
Optional Drain Cap Optional Drain Cap
(not shown)
Wire Mounting Hanger &
Suction Cups
Optional Drain Cap (not shown)
into position. Suction cups will hold Guardian in place
™
Wire Hanging
Bracket and/or
Suction Cups
(not shown)
Optional
Drain Cap
Permanent Mount
(with Mounting Hardware):
Secure the bracket to the surface
by using an appropriate sized
drilled hole: screw into place using
a washer on the front and back of
the bracket (permanent mounting
hardware not included). Slide the
bracket into positioning using the
holes and screw tight into place.
NOTE: Consult your health
department and equipment manual
before permanently mounting
inside an ice or food bin.
Daily cleaning: Remove the Guardian
holding unit from the mounting bracket by
lifting the unit upward to release it from the
bracket locking channels. Clean and sanitize
the scoop and Guardian using standard
manual or mechanical ware-washing
procedure and equipment. Commercial
dishwasher safe.
Suction
Cups